The 7075 aviation aluminum CNC fuselage is made of strengthening aluminum alloy including YFS screws with the 12.9 level hardness to ensure a good performance in wear resistance and compression resistance.
Leopard print fuselage with low gravity center to improve the stability of the balance.
3K high-strength carbon fiber plate to ensure a strong frame and achieve a flexible flight.
Stretch-X structure is designed for easier to adjust PID and which is suitable for competition.
230mm wheelbase for the air passing smoothly to achieve minimal drag coefficient,which makes the drone in a higher speed.
Caddx Ratel 2.1mm lens and adjustable camera angle of 0-60 degrees provides a good shooting experience,
Any problem, please contact us without hesitation. Honor to serve you.
Main Material: 3K carbon fiber
Propeller: GEP5040 * 3 (10 pairs)
Motor: GR2306 2450kv motor
Arm thickness: 4mm
Side panel thickness: 2mm
The remaining plate thickness: 1.5mm
Flight controller firmware: OMNIBUSF4SD
Flight Controller: SPAN F4 Tower AIO
Camera: Caddx Ratel 2.1mm (600TVL)
Input Voltage: 2-5S Lipo
Flight Control: SPAN F4 Tower AIO
ESC: 4 * 40A BLHeli_s (Dshot 150/300/600) support 2~5S LiPo
Image Transmission: 5.8GHz (48 Channel) (PIT/25/200/600mW)
Supported Battery: 2-5S Li-po battery
Drone weight: 342g
Drone Size: 22.2 * 17.8cm
Package size: 25 * 25 * 7cm / 9.84 * 9.84 * 2.75in
Package weight: 500g
Gift box package.
* There could be a few deviations due to manual measurement or slight color difference owing to photographing condition. Thank you for your understanding.
* Don't continue flying over 3-4 batteries without a break, not conducive to maintain aircraft.
* Don't throw it into fire or water.
1 * Leopard RC Quadcopter (PNP version without controller, receiver and battery)